HP jetdirect 175x Administrator's Manual page 96

Hp jetdirect 175x printer-accessory: user guide
Hide thumbs Also See for jetdirect 175x:
Table of Contents

Advertisement

Table 3.4
Telnet Commands and Parameters (16 of 18)
DLC/LLC Settings
Command
dlc/llc-config
strict-8022
Other Settings
Command
link-type
laa
webscan-config
scan-idle-timeout
scan-email-config
MFP-config
ENWW
Description
Enables or disables DLC/LLC protocol operation on the print
server. 0 disables, 1 (default) enables. For example,
dlc/llc-config 0 will disable DLC/LLC operation.
Controls DLC/LLC protocol interpretation:
0 (default): disables, that is, provides loose interpretation.
1: enables, that is, provides strict interpretation).
Description
(10/100 Fast Ethernet) Sets the print server's link speed (10
or 100 Mbps) and communication mode (Full- or
Half-Duplex). Selections are AUTO, 100FULL, 100HALF,
10FULL, 10HALF.
For AUTO (default), the print server uses autonegotiation to
determine the link speed and mode. If autonegotiation fails,
then 100HALF is set.
Specifies a locally administered address (LAA) that replaces
the factory-assigned LAN Hardware (MAC) address. If LAA
is used, a user-specified string of exactly 12 hexadecimal
digits must be entered.
For Token Ring print servers, the LAA address must start
with hexadecimal 40 through 7F.
For Ethernet print servers, the LAA address must start with
hexadecimal X2, X6, XA, or XE, where X is any hexadecimal
digit 0 through F.
The default address is the factory-assigned address.
(Web Scan Config) Enables or disables the Web Scan
feature on the print server when connected to a supported
device. 0 disables, 1 (default) enables.
Specifies the number of seconds (1 - 3600) that an idle scan
connection is allowed to remain open. 0 disables the
timeout. The default is 300 seconds.
(Email Scan Config) Enable or disable the scan-to-email
feature in the Web Scan server. 0 disables, 1 (default)
enables.
(MFP config) Enable or disable print server support of the
client software provided with your multifunction or all-in-one
peripheral.
0 (default): disables client software support (allows printing
only).
1: enables client software support (allows printing and
scanning).
TCP/IP Configuration 96

Advertisement

Table of Contents
loading

Table of Contents