Table C.2
HP Jetdirect Graphical Control Panel Menu (6 of 7)
Menu Item
Options
MANUAL SETTINGS (Available only if CONFIG METHOD is set to
DNS SERVER
IPX/SPX
ENABLE
FRAME TYPE
SOURCE ROUTING
ENWW
Description of settings
MANUAL) Configure parameters directly
from the printer control panel:
G
IP ADDRESS n.n.n.n: The unique IP
address of the printer, where n is a value
from 0 to 255.
G
SUBNET MASK m.m.m.m: The subnet
mask for the printer, where m is a value
from 0 to 255.
G
SYSLOG SERVER n.n.n.n: The IP
address of the syslog server used to
receive and log syslog messages.
G
DEFAULT GATEWAY n.n.n.n: The IP
address of the gateway or router used for
communications with other networks.
G
IDLE TIMEOUT: The time period, in
seconds, after which an idle TCP print
data connection is closed (default is 270
seconds, 0 disables the timeout).
(620n Only) Specify the IP address (n.n.n.n)
of the DNS Server.
ON: Enable the IPX/SPX protocol
OFF: Disable the IPX/SPX protocol
Selects the frame type setting for your
network.
AUTO (default): Automatically sets and limits
the frame type to the first one detected.
EN_8023, EN_II, EN_8022, EN_SNAP:
Frame type selections for Ethernet
networks.
TR_8022, TR_SNAP: Frame type selections
for Token Ring networks.
(Token Ring only) Specify the NetWare
Source Routing parameter
AUTO (default): The type of source routing
required on the network is automatically
sensed
OFF: All packets are sent without source
routing, and only packets from the same
ring are received.
ALL ROUTES and SINGLE ROUTES: All
packets are sent with source routing
(broadcasts, and when the route is
unknown)
The HP Jetdirect Control Panel Menu 288