HP jetdirect 175x Administrator's Manual page 242

Hp jetdirect 175x printer-accessory: user guide
Hide thumbs Also See for jetdirect 175x:
Table of Contents

Advertisement

Table 9.12
Error Messages (11 of 11)
Error Code and
Message
62 DEFAULT IP
CONFIGURED
63 AUTO IP IN
PROGRESS
64 INVALID
PASSWORD
83 DISCONNECTING
FROM SERVER
84 DHCP LEASE
TIMERS ADJUSTED
86 FOR
MULTILANGUAGES
UPGRADE AGAIN
F1 TRYING TO
CONNECT TO
SERVER
F2 TFTP IN
PROGRESS
F3 BOOTP/RARP IN
PROGRESS
F4 BOOTP/DHCP IN
PROGRESS
ENWW
Description
An IP address could not be retrieved over the network.
The print server will default to a legacy default IP address
192.0.0.192.
The print server is automatically assigning an IP address
using link-local addressing in the form 169.254.x.x.
An invalid password was specified through TFTP. Verify that
the password consists of a maximum of 16 printable
characters.
The server has been shut down because of a configuration
change or reset request. This message automatically clears
after a few seconds, unless the printer is offline, is in an error
state, or is servicing another I/O port or another network
protocol.
The print server detected a DHCP lease error due to one of
the following conditions:
G
Renew time is less than 30 seconds.
G
Rebind time is less than 52 seconds.
G
Rebind time is less than, or equal to, the Renew time.
G
The lease duration is less than, or equal to,
the Rebind time.
When upgrading a supported print server that contains a
firmware version prior to X.24.00, it will be necessary to
perform the firmware upgrade again if you want the print
server to support management tools (for example, the
embedded Web server) using non-English languages.
The HP Jetdirect print server is trying to connect to the
NetWare server(s). This is a normal message. Wait until
either the connection is established or another status
message appears.
The print server is attempting to use TFTP to obtain TCP/IP
configuration settings over the network.
The print server is attempting to use BootP or RARP to
obtain TCP/IP configuration settings over the network.
The print server is attempting to use BootP or DHCP to
obtain TCP/IP configuration settings over the network.
HP Jetdirect Configuration Page 242

Advertisement

Table of Contents
loading

Table of Contents