Resolving Printer Display Error Messages - HP jetdirect 175x Administrator's Manual

Procedure 3: Resolving Printer Display
Error Messages
Check the following information to resolve network-related error
messages that appear on the printer control panel display. This
information assumes you have already printed a configuration page.
1. Does the printer's control panel display messages similar to the
following?
EIO X NOT FUNCTIONAL
8X.YYYY EIO ERROR
(where X is the EIO slot number and YYYY is an error code)
Refer to your printer manuals to interpret the error message.
I
If you upgraded the Jetdirect firmware recently, power the
I
print server off/on. For internal Jetdirect cards, turn the
printer off and back on again.
Reinstall the HP Jetdirect print server to ensure it is installed
I
correctly, and verify all connectors are fully mated.
If possible, print an HP Jetdirect configuration page and verify
I
all configuration parameters. To interpret HP Jetdirect
configuration page messages, see
If your printer contains multiple EIO slots, try using a
I
different slot.
Turn off the printer, remove the HP Jetdirect print server, and
I
turn the printer back on. If the error message disappears when
the print server is removed, it is likely that the print server
was causing the error. Replace the print server.
Record all error codes and contact your service provider. If you
I
need to replace the HP Jetdirect print server under warranty
service, include all diagnostic and configuration pages with the
faulty print server.
2. Does EIOX INITIALIZING/DO NOT POWER OFF appear on the
display?
Wait for ten minutes to see if it clears. If it does not, you may
need to replace the HP Jetdirect print server.
ENWW
Troubleshooting the HP Jetdirect Print Server 194
Chapter 9.