HP jetdirect 175x Administrator's Manual page 77

Hp jetdirect 175x printer-accessory: user guide
Hide thumbs Also See for jetdirect 175x:
Table of Contents

Advertisement

To use the route command, you will also need the IP address of your
workstation. To view it, you can enter the appropriate command at
the command prompt:
C:\> ipconfig
C:\> winipconfig
To create a route from the system command prompt, enter the
following command:
route add <Jetdirect IP Address> <system IP Address>
where <Jetdirect IP address> is the IP address configured on
the HP Jetdirect print server, and <system IP address> is the
IP address of the workstation's network card that is attached to the
same physical LAN as the print server.
For example, to create a route from your workstation with IP
address 169.254.2.1 to a print server with a default IP address of
192.0.0.192, try this command:
route add 192.0.0.192
CAUTION
ENWW
(on Windows NT/2000/XP)
(on Windows 98)
169.254.2.1
Using Telnet to manually set an IP address will
override dynamic IP configuration (such as
BOOTP, DHCP, or RARP), resulting in a static
configuration. In a static configuration, the IP
values are fixed and the operation of BOOTP,
DHCP, RARP and other dynamic configuration
methods may no longer function.
Whenever you are manually changing an IP
address, you should also reconfigure the subnet
mask and default gateway at the same time.
TCP/IP Configuration 77

Advertisement

Table of Contents
loading

Table of Contents