HP jetdirect 175x Administrator's Manual page 280

Table C.1 HP Jetdirect Classic Control Panel Menu (4 of 6)
Menu Item
TCP/IP=
IPX/SPX=
DLC/LLC=
ATALK=
ENWW
Description
ENCRYPT: For static WEP encryption, this item appears if
AUTH.=OPEN (Open System), AUTH.=SHARED (Shared
Key), or EAP-MD5=ON. Choose an encryption level:
I 128 for 104/128-bit encryption
I 64 for 40/64-bit encryption
I NONE (default).
TX KEY: This item appears if you selected 128- or 64-bit
encryption and is used to specify the active transmit key.
Choose one of the transmit encryption key positions (key 1, 2,
3, or 4). The selected transmit key must have a valid WEP key
value assigned. If a valid WEP key is not assigned, the first key
found with a valid key will be assigned.
CFG KEY #: Use this menu to configure key values for up to four
key positions (where # identifies the key).
NO (default): Bypass configuration of this key.
YES: Configure a key value for this key.
The format for entering key values is hexadecimal entries with
alphanumeric assist. Hexadecimal digits (0 - 9, A - F) are
entered one byte (two digits) at a time, and an alphanumeric
character for that value will be displayed.
For 40/64-bit encryption, enter 5 bytes (10 digits). For
104/128-bit encryption, enter 13 bytes (26 digits).t
802.11B: Choose to keep or reset the 802.11b wireless
parameters on the print server.
I KEEP: Configured parameters are maintained.
I RESET: Parameters will be reset to factory-default values.
Parameter values for other network protocols are not reset.
To view the reset values, you must exit and reenter the
control panel menu.
Identifies whether the protocol stack is enabled or disabled.
ON (default): The protocol is enabled.
OFF: The protocol is disabled.
The HP Jetdirect Control Panel Menu 280