HP jetdirect 175x Administrator's Manual page 93

Table 3.4 Telnet Commands and Parameters (13 of 18)
DHCP Rebind Time
SNMP Main Settings
Command
snmp-config
get-cmnty-name
set-cmnty-name
default-get-cmnty
SNMP Traps
Command
auth-trap
ENWW
(Read-only parameter) DHCP T2 timeout, specifying the
DHCP lease rebind time (seconds).
Description
Enables or disables SNMP operation on the print server.
0 disables, 1 (default) enables SNMP.
CAUTION: Disabling SNMP will disable all SNMP agents
(SNMP v1, v2, v3) as well as communications with
management applications, such as HP Web Jetadmin. In
addition, firmware upgrades through current HP
downloading utilities will be disabled.
Specifies a password that determines which SNMP
GetRequests the HP Jetdirect print server will respond to.
This is optional. If a user-specified get community name is
set, the print server will respond to either a user-specified
community name or the factory-default. The community
name must be ASCII characters. The maximum length is
255 characters.
Specifies a password that determines which SNMP
SetRequests (control functions) the HP Jetdirect print server
will respond to. The community name of an incoming SNMP
SetRequest must match the print server's "set community
name" for the print server to respond. (For additional
security, you may limit configuration access through the print
server's host access list.) Community names must be ASCII
characters. The maximum length is 255 characters.
Enables or disables the default Get community name.
0 disables, 1 (default) enables.
Disabling this parameter may prohibit communications with
SNMP management applications.
Description
Configures the print server to send (on) or not send (off)
SNMP authentication traps. Authentication traps indicate
that an SNMP request was received, but the community
name check failed. 0 is off, 1 (default) is on.
TCP/IP Configuration 93