Using Telnet To Erase The Existing Ip Settings; Using The Embedded Web Server - HP jetdirect 175x Administrator's Manual

Hp jetdirect 175x printer-accessory: user guide
Hide thumbs Also See for jetdirect 175x:
Table of Contents

Advertisement

Using Telnet to Erase the Existing IP Settings

To erase the IP address during a Telnet session, use the following
command line entries:
1. Type cold-reset, then press Enter.
2. Type quit, then press Enter to exit Telnet.
3. Power the print server off/on.
Note

Using the Embedded Web Server

You can set IP parameters on HP Jetdirect print servers that
support the embedded Web server. For more information, refer to
Chapter
4.
ENWW
This procedure resets all TCP/IP parameters, but
only affects the TCP/IP subsystem. Parameters for
other subsystems such as IPX/SPX or AppleTalk are
not affected.
To reset all parameters to factory default values,
refer to
Chapter
8.
TCP/IP Configuration 100

Advertisement

Table of Contents
loading

Table of Contents