HP jetdirect 175x Administrator's Manual page 239

Table 9.12 Error Messages (8 of 11)
Error Code and
Message
3A NDS ERR: UNABLE
TO FIND TREE
3B NDS
CONNECTION STATE
ERROR
3C NDS ERR:
UNRESOLVED
QUEUE
3D NDS ERR:
CANNOT READ Q
HOST
3E NDS PRNT SRVR
PUBLIC KEY ERR
3F UNABLE TO GET
NDS SRVR ADDR
40 ARP DUPLICATE IP
ADDRESS
41 NOVRAM ERROR
42 INVALID IP
ADDRESS
43 INVALID SUBNET
MASK
44 INVALID GATEWAY
ADDRESS
45 INVALID SYSLOG
ADDRESS
ENWW
Description
The NDS tree cannot be located. The message may occur
when the file server is not running or when a network
communications problem exists.
The HP Jetdirect print server cannot change the NDS
connection state. Check licenses on the spooling server.
The print queue object cannot be located in the specified
NDS context.
Cannot locate the file server on the network. The server may
not be running at this time or a communications problem
may exist.
Print Server Object Name mismatch. Unable to read the
print server's public key. Verify object names. Verify that the
object key assigned to the HP Jetdirect print server is a print
server object and not a printer or other object.
The NDS server address cannot be located or accessed.
The ARP layer has detected another node on the network
using the same IP address as the HP Jetdirect print server.
Extended error information below this message shows the
hardware address of the other node.
The HP Jetdirect print server cannot read the contents of its
NOVRAM.
The IP address specified for the HP Jetdirect print server
(through BOOTP) is an invalid IP address for specifying a
single node. Check your Bootptab file for proper entries.
The IP subnet mask specified for the HP Jetdirect print
server (through BOOTP) is an invalid subnet mask. Check
your Bootptab file for proper entries.
The default gateway IP address specified for the
HP Jetdirect print server (through BOOTP) is an invalid IP
address for specifying a single node. Check your Bootptab
file for proper entries.
The syslog server IP address specified for the HP Jetdirect
print server (through BOOTP) is an invalid IP address for
specifying a single node. Check your Bootptab file for proper
entries.
HP Jetdirect Configuration Page 239