Running Configuration - HP MSR Series Command Reference Manual

Usage guidelines
CAUTION:
A device reboot might interrupt network services.
•
If the main startup software images are corrupted or missing, you must re-specify a set of main startup
•
software images before using the reboot command to reboot the device. Otherwise, the device cannot
start up.
Use the force keyword only when the device fails or a reboot command without the force keyword
•
cannot perform a reboot task correctly. A reboot command with the force keyword might result in file
system corruption because it does not perform any data protection.
For data security, the device does not reboot if you reboot the device while the device is performing file
operations.
To reboot the entire device, do not specify the slot number option. To reboot a card, specify the slot
number.
Examples
# Reboot the device when no configuration change has occurred since the last time you saved the

running configuration.

<Sysname> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# If any configuration has changed, reboot the device and save the configuration.
<Sysname> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
Current configuration will be lost after the reboot, save current configuration? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
flash:/startup.cfg exists, overwrite? [Y/N]:y
Validating file. Please wait...
Configuration is saved to flash successfully.
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# If any configuration has changed, reboot the device but do not save the configuration.
<Sysname> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
Current configuration will be lost after the reboot, save current configuration? [Y/N]:n
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Reboot the device immediately without performing any software check.
<Sysname> reboot force
A forced reboot might cause the storage medium to be corrupted. Continue? [Y/N]:y
Now rebooting, please wait...
# On an MSR4000, reboot the interface card in slot 2.
253