Table of Contents
Advertisement
PROJECTOR FUNCTIONS (UTILITY STITCHES AND CHARACTER/DECORATIVE STITCHES)
Specifying the Sewing End Point
Note
• Using the same material and stitch pattern as
your project, sew trial stitches to check the
result. The machine's sewing end point may
become misaligned in the following cases:
- The end point sticker is loose.
- The fabric was not sewn straight.
- The fabric was pushed too hard during
feeding.
- Fabrics difficult to sew, such as
heavyweight, quilted, stretchy, or thin
fabrics, were used.
a
Select a stitch.
b
Touch
, make sure that [Temporary Stop]
in the machine settings screen is set to
[OFF], and then touch
c
Touch
to set [Guideline] to [ON]. Set
the [Main] line horizontal position
according to the selected stitch pattern.
And then touch
Memo
• If
is selected for [Sub], a grid will be
displayed.
d
Touch
.
86
.
.
e
Touch
.
Memo
• If
appears in light gray and is not available,
the sewing end point cannot be specified with
the selected stitch pattern. Select a different
stitch pattern.
• Automatic reinforcement stitching function
and automatic thread cutting function cannot
be used when using this function.
f
Touch
to select whether or not
sewing is ended with a complete stitch
pattern.
If necessary, touch
selection.
The length of the stitch pattern is adjusted
so that sewing will stop at the specified
end point with a complete stitch pattern.
If this key appears in light gray and is not
available, this function cannot be used.
This adjustment may cause the stitch
pattern to be sewn slightly stretched
vertically.
The end of stitching is not adjusted. When
the end point is reached, sewing stops
immediately, even if the stitch pattern is
not complete.
after making your
Advertisement
Table of Contents
