Table of Contents
Advertisement
Note
• When using the spool as shown below, use
the thread spool insert (mini king thread
spool). Make sure that the thread spool insert
is firmly inserted. After installing it, pull out
some thread, and check that the thread
unwinds without getting caught.
• When using thread that winds off quickly,
such as transparent nylon thread or metallic
thread, place the spool net over the spool
before placing the spool of thread onto the
spool pin.
If the spool net is too long, fold it to fit the size
of the spool.
a Spool net
b Thread spool
c Spool pin
d Spool cap
* When threading the spool with the spool net
on, make sure that 5-6cm (approx. 2 - 2-1/2
inches) of thread is pulled out.
* It may be necessary to adjust the thread
tension when using the spool net.
e
a Thread spool
insert (mini king
thread spool)
b Hole diameter 8.0
mm to 10.5 mm
(5/16 inch to 13/
32 inch)
c Spool (cross-
wound thread)
f
g
With your right hand, hold the thread near
the thread spool. With your left hand, hold
the end of the thread, and use both hands to
pass the thread through the thread guide.
a Thread guide
Pass the thread around the pretension disk
making sure that the thread is under the
pretension disk.
a
a Pretension disk
Make sure that the thread passes under the
pretension disk.
b Pretension disk
c Pull it in as far as possible.
Check to make sure thread is securely set between
pretension disks.
Wind the thread clockwise around the
bobbin 5-6 times.
LOWER THREADING
41
2
Advertisement
Table of Contents
