Table of Contents
Advertisement
PROJECTOR FUNCTIONS (UTILITY STITCHES AND CHARACTER/DECORATIVE STITCHES)
Memo
• If [End Point Setting] is set to [ON], the stitch
pattern cannot be projected by the projector.
• To cancel [End Point Setting], set [End Point
Setting] to [OFF], and then touch
g
With a chalk pencil, mark the fabric with
lines for sewing the stitch pattern and for
the end of stitching.
h
Affix an end point sticker, avoiding the
sewing area. Attach the end point sticker
within 4 cm (approx. 1-1/2 inches) to the
left or right of the chalkline where the end
point for sewing has been drawn.
a 4 cm (Approx. 1-1/2 inches)
Memo
• If the end point sticker can be affixed to either
left or right of the sewing position, we
recommend affixing it to the left side.
• We recommend affixing the end point sticker as
close as possible to the sewing position.
• If you cannot affix an end point sticker
avoiding the sewing area, refer to "Temporary
Stop Setting" on page 87.
• The horizontal guideline at the needle
indicates the distance from the stitching line
where the end point sticker can be affixed.
a 4 cm (Approx. 1-1/2 inches)
b Guideline
i
Place the fabric in the machine, and then
lower the presser foot.
Note
• Before sewing, make sure that the end point
sticker has not become detached. In addition,
make sure that the end point sticker is not
covered with your hand. Otherwise, the
machine cannot detect the end point sticker.
.
a
a
j
Press the "Start/Stop" button to start sewing.
When the foot controller is plugged in,
press down on the foot controller.
Gently guide the fabric to sew the stitching
straight.
Note
• While making sure that the guidelines align
with the lines drawn with the chalk pencil, sew
the stitching straight, not at an angle.
• Do not forcefully feed the fabric. Otherwise,
sewing may not stop correctly.
The machine stops at the specified end point
automatically.
Memo
• If the stitch pattern could not be adjusted when
was set in step
message appears. Cancel [End Point Setting],
and then select a different stitch or change the
length of the stitch.
k
Peel off the end point sticker.
■ Temporary Stop Setting
If you cannot affix an end point sticker that avoids
the sewing area, you can adjust the machine settings
to temporarily stop sewing to allow the sticker to be
removed as you approach the end point sticker.
a
Select a stitch.
b
Touch
, set [Temporary Stop] in the
machine settings screen to [ON], and then
touch
.
c
c
Perform steps
the Sewing End Point" on page 86.
f
, the following
f
through
in "Specifying
2
87
Advertisement
Table of Contents
