Names Of Machine Parts And Their Functions - Brother 882-W33 Operation Manual

NAMES OF MACHINE PARTS AND THEIR FUNCTIONS

NAMES OF MACHINE PARTS AND THEIR FUNCTIONS
■ Front View
c
a
q
*
p
o
n
* Camera and projector (built-in)
IMPORTANT
• Do not place any object weighing 1 kg (2.2 lb)
or more on the top cover, otherwise the cover
may be damaged.
• Do not touch the camera or projector.
Otherwise, it will not display properly.
a Top cover
Open the top cover when threading the machine or winding the
bobbin.
b Pretension disk
Pass the thread around the pretension disk when winding the
bobbin thread. (page 40)
c Thread guide for bobbin winding
Pass the thread through this thread guide when winding the
bobbin thread. (page 40)
d Spool pin
Place a spool of thread on the spool pin. (page 47)
e Spool cap
Use the spool cap to hold the spool of thread in place.
(page 47)
f Supplemental spool pin
Use this spool pin to wind the bobbin thread, or to sew with the
twin needle. (page 40, page 50)
g Bobbin winder
Use the bobbin winder when winding the bobbin. (page 40)
h Bobbin winding slider
Adjust the amount of thread wound onto the bobbin. (page 42)
i LCD (liquid crystal display)
Settings for the selected stitch and error messages appear in
the LCD. (page 19)
j Speaker
k Knee lifter
Use the knee lifter to raise and lower the presser foot. (page 77)
l Knee lifter slot
Insert the knee lifter into the slot. (page 77)
m Operation buttons (7 buttons) and sewing speed
controller
Use these buttons and the slide to operate the machine.
(page 13)
n Needle plate lever
Slide the lever toward you to remove the needle plate.
(page 178)
o Flat bed attachment with accessory compartment
Store presser feet and bobbins in the accessory compartment
of the flat bed attachment. When sewing cylindrical pieces,
remove the flat bed attachment. (page 14)
p Thread cutter
Pass the threads through the thread cutter to cut them.
(page 49)
12
e f
g
h
i
j
l
m
k
q Thread guide plate
Pass the thread around the thread guide plate when threading
upper thread. (page 47)
■ Right-side/Rear View
l
k
j
i
h
g
f
a Connector for the presser foot
Connect the compact dual feed foot or embroidery foot with
LED pointer (sold separately). (page 59)
b Handle
Carry the machine by its handle when transporting the
machine.
c Presser foot lever
Raise and lower the presser foot lever to raise and lower the
presser foot. (page 57)
d Air vent
The air vent allows the air surrounding the motor to circulate.
Do not cover the air vent while the machine is being used.
e Main power switch
Use the main power switch to turn the machine ON and OFF.
(page 17)
f Advanced multi-function foot controller
Use the advanced multi-function foot controller to operate the
machine. (page 63)
g Power cord receptacle
Insert the power cord into the machine receptacle. (page 17)
h Dual purpose stylus holder connector
Connect the included dual purpose stylus holder. (page 81)
i Foot controller jack
Insert the foot controller plug into its jack on the machine.
(page 64)
j USB port
In order to send stitch patterns and embroidery patterns from/
to USB media, plug the USB media directly into the USB port.
k SD card slot
Insert an SD card into the SD card slot in order to import/export
stitch patterns and embroidery patterns.
l Handwheel
Rotate the handwheel toward you (counterclockwise) to raise
and lower the needle. The wheel should be turned toward the
front of the machine.
a
c
e