Utility Stitches And Character/Decorative Stitches; Specifying The Sewing End Point - Brother Upgrade KIT II Operation Manual

This manual provides details on the functions added/upgraded. Before using this manual, upgrade your
machine according to the procedure in the Installation Guide. Before using the functions described in this
manual, read the Operation Manual included with the machine.
The screen illustrations in this manual may differ from actual ones shown on the machine.
Utility Stitches and
Character/Decorative
Stitches

Specifying the Sewing End Point

Note
Using the same material and stitch pattern as
your project, sew trial stitches to check the
result. The machine's sewing end point may
become misaligned in the following cases:
• The end point sticker is loose.
• The fabric was not sewn straight.
• The fabric was pushed too hard during
feeding.
• Fabrics difficult to sew, such as
heavyweight, quilted, stretchy, or thin
fabrics, were used.
a
Select a stitch.
b
Press , make sure that "Temporary Stop"
in the machine settings screen is set to
"OFF", and then press
c
Press to set "Guideline" to "ON". Set
the "Main" line horizontal position
according to the selected pattern. And then
press .
Memo
• If is selected for [Sub], a grid will be
displayed.
d
e
.
f

Utility Stitches and Character/Decorative Stitches

Press .
Press .
Memo
• If appears in light gray and is not
available, the sewing end point cannot be
specified with the selected stitch pattern.
Select a different stitch pattern.
Press to select whether or not
sewing is ended with a complete pattern.
If necessary, press
selection.
after making your
2