Table of Contents
Advertisement
LOWER THREADING
h
Pass the end of the thread through the guide
slit in the bobbin winder seat, and pull the
thread to the right to cut the thread with
the cutter.
a Guide slit (with built-in cutter)
b Bobbin winder seat
CAUTION
• Be sure to follow the process described.
Winding the bobbin without cutting the thread
with the cutter may cause the bobbin to be
wound incorrectly. In addition, the thread may
become tangled around the bobbin when the
bobbin thread starts to run out, possibly
causing the needle to break, resulting in
injuries.
i
Set the bobbin winding switch to the left,
until it clicks into place.
a Bobbin winding switch
Memo
• Use the bobbin winding slider to adjust the
amount of thread wound onto the bobbin to
one of five levels.
a Bobbin winding slider
b More
c Less
The bobbin winding window appears.
42
j
a
Touch
.
a
a Touch to decrease the winding speed.
b Touch to increase the winding speed.
Bobbin winding starts.
while the bobbin is winding. The bobbin stops
rotating when bobbin winding is completed. The
bobbin winding switch will automatically return to
its original position.
Memo
• Stay near the machine while winding the
bobbin to make sure the bobbin thread is
being wound correctly. If the bobbin thread is
wound incorrectly, touch
• Touch
to minimize the bobbin winding
window. Then, you can perform other
operations, such as selecting a stitch or
adjusting the thread tension, while the bobbin
is being wound.
• Touch
(in top right of the LCD screen) to
display the bobbin winding window again.
• The sound of winding the bobbin with stiff
thread, such as nylon thread for quilting, may
be different from the one produced when
winding normal thread; however, this is not a
sign of a malfunction.
IMPORTANT
• When winding transparent nylon thread on the
bobbin, stop bobbin winding when the bobbin
is 1/2 to 2/3 full. If the bobbin was fully
wound with transparent nylon thread, it may
not be wound neatly, or sewing performance
may suffer. In addition, extreme pressure may
be applied to the bobbin, it may not be
possible to remove the bobbin from the bobbin
winder shaft, or the bobbin may break.
b
changes to
.
Advertisement
Table of Contents
