Table of Contents
Advertisement
Sewing Curves
Sew slowly while keeping the seam parallel with
the fabric edge as you guide the fabric around the
curve.
Changing Sewing Direction
Stop the machine. Leave the needle in the fabric,
and press the "Presser Foot Lifter" button to raise
the presser foot. Using the needle as a pivot, turn
the fabric so that you can sew in the new
direction. Press the "Presser Foot Lifter" button to
lower the presser foot and start sewing.
The pivot setting is useful when changing the
sewing direction. When the machine is stopped at
the corner of the fabric, the machine stops with the
needle in the fabric and the presser foot is
automatically raised so the fabric can easily be
rotated ("Pivoting" on page 76).
■ Sewing a Seam Allowance of 0.5 cm
or Less
Baste the corner before sewing, and then, after
changing the sewing direction at the corner, pull the
basting thread toward the back while sewing.
a 5 mm (approx. 3/16 inch)
Sewing Heavyweight Fabrics
If the thickness of a seam causes the presser foot to
rest at an angle, help guide the fabric by hand and
sew on the downward slope.
CAUTION
• If fabric more than 6 mm (1/4 inch) thick is
sewn or if the fabric is pushed with too much
force, the needle may break and cause injury.
Memo
• Thicker fabrics require a larger needle.
(page 56)
■ If the Fabric Does Not Fit Under the
Presser Foot
If the presser foot is in the up position, and you are
sewing heavyweight or multiple layers of fabric
which do not fit easily under the presser foot, use
the presser foot lever to raise the presser foot to its
highest position. The fabric will now fit under the
presser foot.
Memo
• You cannot use the presser foot lever after the
presser foot has been raised using the
"Presser Foot Lifter" button.
SEWING
2
69
Advertisement
Table of Contents
