Replacing The Flex Cable; Figure 8-19 Connecting/Disconnecting The Flex Cable-The Cpu Board - Sun Microsystems SPARCstation Voyager Service Manual

Flex cable
FIGURE 8-19
5. Remove the flex cable from the system.

Replacing the Flex Cable

1. Connect the replacement flex cable to the CPU board.
See
FIGURE 8-19
2. Snap in both bail locks to secure the flex connector to the CPU board.
3. Connect the flex cable to the video board.
See
FIGURE 8-18
4. Replace the disk drive.
See Section "Replacing the Hard Disk Drive" on page 9-94.
5. Close the system and power it on.
82 SPARCstation Voyager Service Manual • December 1994
Connecting/Disconnecting the Flex Cable—the CPU Board
.
.
Bail locks
CPU board