I/O Board; Removing The I/O Board; Figure 10-15 Connecting/Disconnecting The Scsi Cable-The I/O Board - Sun Microsystems SPARCstation Voyager Service Manual

I/O Board

Removing the I/O Board

1. Remove the hard disk drive.
See Section "Removing the Hard Disk Drive" on page 9-92.
2. Disconnect the SCSI cable from the I/O board.
FIGURE 10-15
3. Remove the CPU board.
Section "Removing the CPU Board" on page 10-96.
4. Disconnect the DC harness from the I/O board.
See
FIGURE 10-16
5. Disconnect the IR cable from the I/O board.
6. Remove all screws from the back panel.
See
FIGURE 10-16
108 SPARCstation Voyager Service Manual • December 1994
I/O board
Connecting/Disconnecting the SCSI Cable—the I/O board
.
.
SCSI cable