Sun Microsystems SPARCstation Voyager Service Manual page 64

c. For the system that contains battery and runs on the power supply (slow
charging the battery):
Connect the external DC cable to the DC input connector on the backpanel, and
connect the AC power cable to the wall outlet. See
3. Connect the cables to all external units.
See the manual supplied with each device for instructions.
4. Turn on the power to all external units starting with the unit farthest electrically
from the system unit.
The external units can include external drives, printers, or other serial or parallel
devices.
5. Press the power key on the system unit keyboard, or press the power switch on
the back panel for a system without a keyboard.
See
FIGURE 6-1
42 SPARCstation Voyager Service Manual • December 1994
or . The system will reboot.
FIGURE 6-2
.
FIGURE 6-5