Braun Aesculap Spine Instructions For Use/Technical Description page 12

Aesculap Spine
activ L chisel and chisel guides
Phase I
Completely immerse the product in the cleaner/
disinfectant solution. Ensure that all accessible
surfaces are moistened.
Clean the product with a suitable cleaning brush
until all discernable residues have been removed.
For products with concealed crevices, lumens or
complex geometries, brush non-visible surfaces
with a suitable cleaning brush (brush length:
30 mm/∅: 4,5 mm, e.g. TA011944) for at least 1
min or until all discernable residues have been
removed.
Maneuver non-rigid
adjustable screws, hinges etc during cleaning.
After cleaning, thoroughly rinse through these
components (at least five times) with the cleaning
solution, using a disposable syringe (20 ml).
Do not use metal cleaning brushes or other
abrasives that would damage the product surfaces
and could cause corrosion.
Phase II
Rinse/flush the product thoroughly (all accessible
surfaces) under running water.
10
components, such as