Paper Preheater And Deskew Assembly - Xerox Phaser 8400 Service Manual

Paper Preheater and Deskew Assembly

(PL 3.11)
1. Open the front door.
2.
Remove the lower duplex guide (green) (see page 8-36).
3.
Remove the inner simplex guide (white) (see page 8-36).
4.
Unplug the AC and sensor flag connectors from the bottom of the preheater.
Note
Release the lock on the back of the AC connector.
5. Slide the latches in and forward to latch in their slots as shown by (1) and (2) in
the following figure.
6. Slide the preheater off the shelves and out of the printer as shown by (3).
Replacement Notes
Note
The fingers on the Inner Simplex Guide, go over the segmented roller. First
snap the left retainer into place, then the right.
8-22 Phaser 8400 Printer Service Manual
s8400-088