Xerox Phaser 8400 Service Manual page 312

18.
Connect the Drum Encoder Cable to the Power Control Left Cable.
19. Connect the Drum Thermistor Cable to the I/O Board.
20.
Connect the Exit Module Cable to the I/O Board.
21. Ensure that the Drum Heater Cable and Drum Encoder Cable are dressed
correctly and secured by the retainer hook at the Process Gear Assembly.
22. Reinstall the Drum Fan Assembly and secure it with 3 screws. Torque the top
screw into the Labyrinth Seal to 20 in.-lbs. and the other two screws into the
chassis to 12 in.-lbs.
23.
Pass the Media Release Blade Solenoid cable through the right side of the chassis
and seat the Lower Inner Duplex Guide on the four mounting pins on the chassis.
24.
Install the Inkloader Assembly (see page 8-8).
25.
Reinstall all covers and doors.
Service Parts Disassembly 8-33