Media Release Blade Carriage Assembly And Transfix Roller - Xerox Phaser 8400 Service Manual

Media Release Blade Carriage Assembly and Transfix
Roller
(PL 2.13)
)Videos are available with instructions for replacing the Transfix
Roller. Videos are located on the Phaser 8400 Customer Support
training CD-ROM.
1.
Remove the Right Side Cover (see page 8-5).
2.
Disconnect J250 from the I/O Board.
3.
Remove two screws securing the I/O Board to the chassis, slide the board towards
the rear, and move the board out of the way.
4.
Loosen the screw securing the Transfix Roller Shaft Restraint and remove the
restraint.
Caution
Hold the Transfix Roller and the Media Release Blade with one hand during
removal to prevent the Transfix Roller from falling and damaging the printer.
5. Use the end of the Transfix Roller Shaft Restraint (pickle fork) to pry the shaft
out and remove the shaft from the printer (see figure below).
6. Remove the Media Release Blade and Transfix Roller.
Service Parts Disassembly
s8400-113
8-21