Xerox Phaser 8400 Service Manual page 128

Jam Code Troubleshooting Procedures
P5L Process motor out of position while the printer was in standby mode
1. Verify that the process drive gearbox is correctly aligned.
2. Run diagnostic Check Motors Process Motor test.
P5S Process motor out of position while the printer staged for transfix
1. Verify that the process drive gearbox is correctly aligned.
2. Run diagnostic Check Motors Process Motor test.
P5T Process motor out of position while the printer transfixed the print
1. Verify that the process drive gearbox is correctly aligned.
2. Run diagnostic Check Motors Process Motor test.
P5V Process motor out of position while the printer performed a print drum
maintnenance cycle
1. Verify that the process drive gearbox is correctly aligned.
2. Run diagnostic Check Motors Process Motor test.
P5W Process motor out of position while the printer imaged the drum
1. Verify that the process drive gearbox is correctly aligned.
2. Run diagnostic Check Motors Process Motor test.
P5X Process motor out of position while the print exited the printer
1. Verify that the process drive gearbox is correctly aligned.
2. Run diagnostic Check Motors Process Motor test.
T2A Exit door sensor unexpectedly actuated during abnormal shutdown
The exit door open flag unexpectedly tripped while the printer was performing an
abnormal shutdown
1. Ensure the ground planes and ground straps are intact.
2. Run diagnostic Monitor Sensors test. Inspect the exit flag for damage and
proper operation.
T2B Exit door sensor unexpectedly actuated during normal shutdown
The exit door open flag unexpectedly tripped while the printer was performing a
normal shutdown
1. Ensure the ground planes and ground straps are intact.
2. Run diagnostic Monitor Sensors test. Inspect the exit flag for damage and
proper operation.
T2C Exit door sensor unexpectedly actuated during mechanical recovery
The exit door open flag unexpectedly tripped while the printer was performing a
mechanical recovery
1. Ensure the ground planes and ground straps are intact.
2. Run diagnostic Monitor Sensors test. Inspect the exit flag for damage and
proper operation.
T2D Exit door sensor unexpectedly actuated during warmup
The exit door open flag unexpectedly tripped while the printer was warming up
1. Ensure the ground planes and ground straps are intact.
2. Run diagnostic Monitor Sensors test. Inspect the exit flag for damage and
proper operation.
Error Messages and Codes
(Continued)
3-61