Xerox Phaser 8400 Service Manual page 119

Jam Code Troubleshooting Procedures
F2H Front door sensor unexpectedly actuated during a printhead maintenance cycle
The front door open flag unexpectedly tripped while the printer was performing a
printhead maintenance cycle
1. Ensure ground planes and ground straps are intact.
2. Run the diagnostic Sensors test to test the door sensor.
F2J Front door sensor unexpectedly actuated during a printhead purge cycle
The front door open flag unexpectedly tripped while the printer was performing a
printhead purge cycle
1. Ensure ground planes and ground straps are intact.
2. Run the diagnostic Sensors test to test the door sensor.
F2K Front door sensor unexpectedly actuated during a transfix oiling cycle
The front door open flag unexpectedly tripped while the printer was performing a
transfix oiling cycle
1. Ensure ground planes and ground straps are intact.
2. Run the diagnostic Sensors test to test the door sensor.
F2L Front door sensor unexpectedly actuated during standby mode
The front door open flag unexpectedly tripped while the printer was in Standby
mode
1. Ensure ground planes and ground straps are intact.
2. Run the diagnostic Sensors test to test the door sensor.
F2M Front door sensor unexpectedly actuated during a pick from Tray 2
The front door open flag unexpectedly tripped when the printer pick from Tray 2
1. Ensure the media being used is the correct weight for the tray.
2. Ensure ground planes and ground straps are intact.
3. Run the diagnostic Sensors test to test the door sensor.
F2N Front door sensor unexpectedly actuated during a pick from Tray 3
The front door open flag unexpectedly tripped when the printer pick from Tray 3
1. Ensure the media being used is the correct weight for the tray.
2. Ensure ground planes and ground straps are intact.
3. Run the diagnostic Sensors test to test the door sensor.
F2P Front door sensor unexpectedly actuated during a pick from Tray 4
The front door open flag unexpectedly tripped when the printer pick from Tray 4
1. Ensure the media being used is the correct weight for the tray.
2. Ensure ground planes and ground straps are intact.
3. Run the diagnostic Sensors test to test the door sensor.
F2Q Front door sensor unexpectedly actuated during a pick from Tray 1
The front door open flag unexpectedly tripped when the printer pick from Tray 1
1. Ensure the media being used is the correct weight for the tray.
2. Ensure ground planes and ground straps are intact.
3. Run the diagnostic Sensors test to test the door sensor.
3-52
(Continued)
Phaser 8400 Printer Service Manual