Xerox Phaser 8400 Service Manual page 80

Error Code Definition Table (Continued)
Error code
6,011.6x:
XA_PROGFAULT_XB
6,013.6x:
XA_PROGFAULT_XD
6,017.6x:
XA_PROGFAULT_X11
6,018.6x:
YA_PROGFAULT_X12
6,019.6x:
XA_PROGFAULT_X13
6,023.6x:
XA_PROGFAULT_X17
6,025.6x
XA_PROGFAULT_X19
6,032.6x:
XA_PROGFAULT_X20
6,033.66
XA_PROGFAULT_X21
Error Messages and Codes
Definition
Attempt to service with the x-axis not in the proper state.
1. Reset NVRAM and retest.
2. Ensure that printer ground straps and ground planes
are intact.
1. Unknown x-axis device fault argument.Reset NVRAM
and retest.
2. Ensure that printer ground straps and ground planes
are intact.
1. An attempt was made to drive the x-axis using the
wrong server (not xa).Reset NVRAM and retest.
2. Ensure that printer ground straps and ground planes
are intact.
1. An attempt was made to move with the x-axis
uninitialized.Reset NVRAM and retest.
2. Ensure that printer ground straps and ground planes
are intact.
An attempt was made to move to home from a state
where homing is not allowed (uninitialized or in an
unmovable state). The mechanism must be placed in a
home position first.
1. Reset NVRAM and retest.
2. Ensure that printer ground straps and ground planes
are intact.
Could not allocate memory for x-axis home parameters.
1. Reset NVRAM and retest.
2. Ensure that printer ground straps and ground planes
are intact.
An attempt was made to home with the x-axis
uninitialized.
1. Reset NVRAM and retest.
2. Ensure that printer ground straps and ground planes
are intact.
Could not find a solution to the described motion profile.
1. Reset NVRAM and retest.
2. Ensure that printer ground straps and ground planes
are intact.
Could not allocate memory for the x-axis move
parameters.
1. Reset NVRAM and retest.
2. Ensure that printer ground straps and ground planes
are intact.
3-13