1. Manuals
  2. Brands
  3. Xerox Manuals
  4. Printer
  5. Phaser 8400
  6. Service manual

Xerox Phaser 8400 Service Manual page 142

Hide thumbs Also See for Phaser 8400:
Table of Contents

Advertisement

Jam Code Troubleshooting Procedures
Z2R
Tray 4 Pick Flag Triggered unexpectedly While DupleZing
1.
Ensure the ground straps and ground planes are intact.
2.
Run diagnostic Monitor Sensors test.
Z2V
Tray 4 Pick Flag Triggered unexpectedly While Print Drum Maintenance Cycle
Being Peformed
1.
Ensure the ground straps and ground planes are intact.
2.
Run diagnostic Monitor Sensors test.
Z2W
Tray 4 Pick Flag Triggered unexpectedly While Printer Imaging
1.
Ensure the ground straps and ground planes are intact.
2.
Run diagnostic Monitor Sensors test.
Z2S
Tray 4 Pick Flag Triggered unexpectedly While Paper Staged for Print
1.
Ensure the ground straps and ground planes are intact.
2.
Run diagnostic Monitor Sensors test.
Z2T
Tray 4 Pick Flag Triggered unexpectedly While Transfixing the Print\
1.
Ensure the ground straps and ground planes are intact.
2.
Run diagnostic Monitor Sensors test.
Z2Z
Tray 4 Pick Flag Triggered unexpectedly While Exiting Print
1.
Ensure the ground straps and ground planes are intact.
2.
Run diagnostic Monitor Sensors test.
Z3A
Tray 4 Pick Flag Sensor Timed Out During Abnormal Shutdown
1.
Verify the paper loaded in Tray 4 is the correct size and type.
2.
Inspect/clean the pick roller assembly. Replace if necessary.
3.
Run diagnostic Check Shafts Tray 4 Pick Shaft test
4.
Replace the Tray 4 535-sheet feeder.
Z3B
Tray 4 Pick Flag Sensor Timed Out During Normal Shutdown
1.
Verify the paper loaded in Tray 4 is the correct size and type.
2.
Inspect/clean the pick roller assembly. Replace if necessary.
3.
Run diagnostic Check Shafts Tray 4 Pick Shaft test
4.
Replace the Tray 4 535-sheet feeder.
Z3C
Tray 4 Pick Flag Sensor Timed Out During Mechanical Recovery
1.
Verify the paper loaded in Tray 4 is the correct size and type.
2.
Inspect/clean the pick roller assembly. Replace if necessary.
3.
Run diagnostic Check Shafts Tray 4 Pick Shaft test
4.
Replace the Tray 4 535-sheet feeder
Z3D
Tray 4 Pick Flag Sensor Timed OutDuring Warmup
1.
Verify the paper loaded in Tray 4 is the correct size and type.
2.
Inspect/clean the pick roller assembly. Replace if necessary.
3.
Run diagnostic Check Shafts Tray 4 Pick Shaft test
4.
Replace the Tray 4 535-sheet feeder.
Error Messages and Codes
(Continued)
3-75

Advertisement

Table of Contents
loading

Related Manuals for Xerox Phaser 8400

Related Products for Xerox Phaser 8400

Table of Contents