Hard Disk Drive Activity Light Does Not Activate; Dvd Rom Drive Activity Light Does Not Activate - HP i2000 Owner's Manual

10.5.6 Hard Disk Drive Activity Light Does Not Activate

If hard disk drive activity light does not function, check the following:
c
Is the power and signal cables to the drive properly installed?
c
Are all relevant switches and jumpers on the hard drive and I/O board set
correctly?
c
Is the onboard IDE controller enabled? (IDE hard drives only)?
c
Is the PCI SCSI controller enabled and configured correctly? (SCSI only)?
c
Is the hard disk drive properly configured?
/
NOTE
Front panel hard disk LED indicates IDE and SCSI devices. The hard disk
drive activity light on the front panel lights when either an IDE hard disk drive, or a
SCSI device controlled by the PCI SCSI host controller, is in use. This LED does
not display CD-ROM activity.

10.5.7 DVD ROM Drive Activity Light Does Not Activate

Check the following:
c
Are all relevant switches and jumpers on the drive set correctly?
c
Is the drive properly configured as the master?
c
Is the onboard IDE controller enabled?
/
NOTE
Front panel hard disk LED indicates IDE and SCSI devices. The hard disk
drive activity light on the front panel lights when either an IDE hard disk drive, or a
SCSI device controlled by the onboard SCSI host controller, is in use. This LED
does not display DVD ROM activity.
/
NOTE
PCI peripherals will not operate if used with 32-bit drivers. At this time, there
are a limited number of Itanium
not install any additional PCI peripherals that do not have current Itanium
drivers.
116
hp workstation i2000 owner's guide
-based drivers available for PCI peripherals, do
-based