Baseboard Installation; Fan Installation; Table 24. I/O Admin Jumper - HP i2000 Owner's Manual

8.2

Baseboard Installation

Once verification of the jumper settings on the baseboard, the I/O board, and the
processor board are complete and correctly set, insert the baseboard into the system
chassis and center the board utilizing the baseboard alignment pins 1 and 2 (as shown
in Figure 49). Use the following steps:
1. Apply a small amount of downward pressure to "press fit" the baseboard onto the
alignment pins. The remaining eight- (8) baseboard mounting holes must now be
aligned properly. Insert the eight- (8) baseboard mounting screws and secure
the baseboard to the chassis. Refer to the locations in Figure 49.
2. Reconnect the three- (3) main power supply connectors at the rear of the
baseboard. Refer to Figure 48.
3. Reconnect the forward and rear processor cooling fan connectors J48, J50 and
J5, J8, J11 respectively. Refer to Figure 53.
8.2.1

Fan Installation

1. Attach the fan power connectors to the baseboard power connectors J33 and
J36. Refer to Figure 53.
2. Reinstall the fan card guide by first aligning it with the screw hole and then
snapping it into place (refer to Figure 53). Secure it to the chassis using the
mounting screw.
3. Reinstall the two- (2) memory card retention posts and secure them to the
baseboard using four- (4) screws (two- [2] each). Be sure to place the retention
post, which contains the fan at the front of the baseboard, adjacent to the fan
card guide. Refer to Figure 47.
4. Reconnect the retention post fan power cable to connector J46. Refer to Figure
53.
98

Table 24. I/O ADMIN Jumper

ADMIN (J8C3)
ENABLE
DISABLE
* DEFAULT
hp workstation i2000 owner's guide
1-2
2-3*