Working Inside The System; Tools And Supplies Needed - HP i2000 Owner's Manual

5.

Working Inside the System

5.1

Tools and Supplies Needed

A list of suggested tools and supplies is given below. Observe all warnings and cautions
when accessing the system.
1. Phillips (cross-head) screwdriver (#2).
2. Small flat-bladed screwdriver.
3. Jumper-removal tool or needle-nosed pliers.
4. Anti-static wrist strap and conductive foam pad (recommended).
5. Torque driver (optional).
6. Pen or pencil.
7. Equipment log (found in Appendix B) to record the model and serial number of
the system, all installed options, and any other pertinent information specific to
the system.
CAUTION
Only technically qualified persons shall perform integration/servicing of this
chassis.
Follow these guidelines to meet and maintain safety and product regulatory
compliance when integrating this chassis.
Read and adhere to all of these instructions and the instructions supplied with this
assembly. If you do not follow these instructions, the UL listing and other
regulatory certifications will be void, and the product may be non-compliant with
regional product laws and regulations.
CAUTION
Before removing or installing the i2000 system board or any other system
component, observe all the safety guidelines for safety requirements and
precautions. Always follow the steps in the procedure in the correct order (i.e., as
written). Use Appendix B to record identification information about your computer.
When working on any i2000 system board, wear an anti-static wrist wrap and place
the board on a conductive foam pad.
78
hp workstation i2000 owner's guide