Fan
Card Guide
I/O Card
Retaining
Foot
7.5
Removal of the I/O Board
1. Disconnect all I/O card cables and connectors.
2. Remove the two- (2) screws at the top of the I/O bracket located inside the
system.
3. Remove the screw holding the I/O bracket to the rear of the system (external).
Refer to Figure 46.
4. Remove the screw fastening the plastic retaining foot, at the front of the I/O
board, from the baseboard. Refer to Figure 46.
5. Place this card aside on an anti-static surface.
88
Figure 45. Internal Component Locations
hp workstation i2000 owner's guide
I/O Retaining
Screws
Rear I/O
Retaining Screw
Memory
Card
Retention
Posts