Configuration Manager Tabs; Table 7. Summary Of Configuration Manager Screens - HP i2000 Owner's Manual

To exit Configuration Manager, do the following:
1. Go to the Save/Exit Tab (refer to section 3.13).
2. If you have made changes in the Configuration Manager Settings, choose
Save New Settings or Discard Changes.
3. Choose Exit.
3.2

Configuration Manager Tabs

/
NOTE
For reference purposes, before you begin record the current settings in Appendix
B. When you make changes to the settings, update this record.
The Configuration Manager is accessed at the Intel
Screen (refer to Figure 8) by tabbing to the "Enter Set-up" option and pressing enter.
The Configuration Manager is organized into a set of tabbed panels. Table 7
summarizes the uses for each tab.

Table 7. Summary of Configuration Manager Screens

Tab Legend
Help
System Processors
System Memory
System Event Log
Integrated IDE
System BIOS
Power Events
Time/Date
44
Help on using the Configuration Manager
Displays processor information
Displays the Front Side Bus (FSB) speed
Displays the amount of memory
Displays the memory speed
Displays the ECC setting
Displays the type of memory module in each slot
Configure System Event Log
Mark System Event Log as read
View System Event Log
Controller Enabled
Spin Delay
Configure the Primary and Secondary IDE channels
Displays the BIOS version
Displays the SMBIOS version
Displays the PAL version
Displays the SAL version
Displays the Boot Block version
Enable or disable the S5 wake-up events
Displays and sets the time or date
hp workstation i2000 owner's guide
Itanium™ processor Splash
Uses