If the Hard Disk Activity
Light Does Not Work
HP Kayak XU PC Workstation Troubleshooting Your HP PC Workstation
If the Flexible Disk Drive Does Not Work
Check that you are using a formatted diskette and it is inserted
•
correctly.
Check you are using a diskette that is the correct density.
•
Check that the flexible disk drive is correctly configured in the Setup
•
program (
Advanced > Flexible Disk Drives
Check that the flexible disk drive is not disabled in the Setup
•
program (
Advanced > Flexible Disk Drives
Check that the
•
Flexible Disks
locked in the Setup program (
Clean the flexible disk drive using a diskette cleaning kit.
•
Check that the disk power and data cables are correctly connected.
•
If the Hard Disk Drive Does not Work
Check that the disk power and data cables are correctly connected.
•
For an IDE drive, check the IDE Device's configuration settings in
•
the Setup program (
For an IDE drive, check the Hardware Protection settings in the
•
Setup program (
For an IDE drive, check the Boot Device Security settings in the
•
Setup program (
For a SCSI drive, check the SCSI interface settings in the Setup
•
program at
Advanced > Internal Wide 16-bit SCSI or External\Internal 16\8-bit
and in the SCSISelect Utility (Adaptec)or the Configure SCSI
SCSI,
Utility (Symbios). For more information, refer to the SCSI
Administrator's Guide available from HP's web site.
If the hard disk activity light does not flicker when the PC Workstation
is accessing the hard disk drive:
Check that the control panel connector is firmly attached to the
•
system board.
Check that the disk power and data cables are correctly connected.
•
Check that the external start cable on the combined SCSI/LAN board
•
is properly connected.
If Your PC Workstation Has a Hardware Problem
).
and the
Write on Flexible Disks
Security > Hardware Protection
Advanced > IDE Devices
Security > Hardware Protection
Security > Boot Devices Security
).
items are not
).
).
).
).
English
15