Solving Problems; Resetting The System; Initial System Startup; Startup Checklist - HP i2000 Owner's Manual

Hp i2000: owners guide
Hide thumbs Also See for i2000:
Table of Contents

Advertisement

10.

Solving Problems

This chapter helps you identify and solve problems that may occur while you are using the hp
workstation i2000.
10.1

Resetting the System

Soft boot reset, which clears system memory and reloads the operating system.
Cold boot reset, which clears system memory, restarts POST, and initializes all peripherals.
Hold the power button for 4 seconds to Power off.
Hard reset, which also clears system memory, restarts POST, and initializes all peripherals.
10.2

Initial System Startup

Incorrect installation or configuration usually causes problems that occur at initial system
startup. Hardware failure is a less frequent cause.

10.2.1 Startup Checklist

c
Are the processors fully seated in their connectors on the processor board?
c
Is at least one- (1) memory board installed and fully seated?
c
Are all add-in PCI boards fully seated in their slots on the baseboard?
c
Are all switch and jumper settings on boards and drives correct?
c
Are all switch and jumper settings on add-in cards and peripheral devices
correct? To check these settings refer to the manufacturer's documentation that
comes with them. If applicable, ensure that there are no conflicts - for example,
two- (2) add-in cards sharing the same interrupt.
c
Are all DIMMs installed correctly?
c
Are all memory board voltage modules installed correctly?
c
Are all peripheral devices installed correctly?
c
Is the hard disk drive properly formatted or configured?
c
Are all device drivers properly installed?
c
Did you press the system power on/off switch on the front panel to turn the
system on (power-on light should be lit)?
c
Are the system power cords properly connected to the system and plugged into
an outlet for 110-240 VAC?
c
Is AC power available at the wall outlet?
To do this:
hp workstation i2000 owner's guide
Press:
<Ctrl+Alt+Del>
Power off/on
Press the reset switch
located on a card slot filler
panel at the rear of the
system
109

Advertisement

Table of Contents
loading

Table of Contents