I/O Board Installation; Preparing The I/O Board; Installing The I/O Board - HP i2000 Owner's Manual

8.3

I/O Board Installation

8.3.1

Preparing the I/O Board

To replace or upgrade the I/O board, the mounting bracket must be removed from the
original I/O board and reinstalled on the upgrade I/O board.
1. To remove the I/O mounting bracket from the I/O board, remove the two- (2)
Phillips-head screws securing the board to the bracket.
2. Remove (unsnap) the plastic retaining foot from the I/O PCB.
3. Reverse the procedure by placing the bracket on the upgrade I/O board.
4. Install (snap) on the new PCB.
5. Replace and tighten the two- (2) screws securing the bracket to the board.
8.3.2

Installing the I/O Board

1. Align the I/O bracket to the chassis and the card edge connector into the system
baseboard, ensuring that the I/O card is completely seated into the I/O slot.
2. Reinstall the I/O bracket retaining screw that holds the I/O bracket to the rear of
the system. Refer to Figure 45.
3. Reinstall the two- (2) screws at the top of the I/O bracket, mounting it to the
inside of the system.
4. Reconnect all the connectors and cables. Refer to Figure 54 for connection
locations on the I/O board.
CAUTION
When you install the I/O Board, avoid damaging the EMI gaskets mounted on the
rear. Replace any damaged strips, or your system may not meet EMI
requirements.
hp workstation i2000 owner's guide
99