HP i2000 Owner's Manual page 104

hp workstation i2000 owner's guide
Which Pins To Jumper.
First, determine which drive is installed in your system. Your drive will be type A, B or C. Then
use the table for the proper pins to jumper on your drive.
Using the jumpers provided, set the SCSI ID on the jumper block located on the bottom of the
hard disk drive. Do not use the 12-pin jumper block next to the power connector.
/
NOTE
Jumpers must be installed vertically. If jumpers are installed horizontally across adjacent pins,
there is no effect. However, this is a good way to store unused jumpers.
104