crystal.bk : cryst-3.fb4 Page 67 Monday, March 23, 1998 4:09 AM
If the Hard Disk Activity
Light Does Not Work
Check that the Flexible Disks item and the Write on Flexible Disks
•
item are not set to locked in the Setup program (Security > Hard-
ware Protection).
Clean the flexible disk drive using a diskette cleaning kit.
•
Check that the disk power and data cables are correctly connected.
•
If the Hard Disk Drive Does not Work
Check that the disk power and data cables are correctly connected
•
(Refer to "Connecting Devices" on page 37).
For an IDE drive, check the IDE Device's configuration settings in
•
the Setup program (Advanced > IDE Devices).
For an IDE drive, check the Hardware Protection settings in the
•
Setup program (Security > Hardware Protection).
For an IDE drive, check the Boot Device Security settings in the
•
Setup program (Security > Boot Devices Security).
For a SCSI drive, check the SCSI Interface settings in the Setup
•
program at Advanced > Internal Wide 16-bit SCSI or External\
Internal 16\8-bit SCSI and in the SCSISelect Utility (Adaptec)or the
Configure SCSI Utility (Symbios).
If the hard disk activity light does not flicker when the PC Workstation
is accessing the hard disk drive:
Check that the control panel connector is firmly attached to the
•
system board.
Check that the disk power and data cables are correctly connected.
•
3 Troubleshooting Your PC Workstation
If Your PC Workstation Has a Hardware Problem
English
67