HP i2000 Owner's Manual page 23

WARNINGS
For proper cooling and airflow, always reinstall the chassis covers before turning on
the system. Operating the system without the covers in place can damage system
parts. To install the covers:
1. Check first to make sure you have not left loose tools or parts inside the system.
2. Check that cables, add-in boards, and other components are properly installed.
3. Attach the covers to the chassis with the screws removed earlier, and tighten
them firmly.
4. Lock the system to prevent unauthorized access inside the system.
5. Connect all external cables and the AC power cord to the system.
The microprocessor, heat sink and Power Pod may be hot if the system has been
running. Also, there may be sharp pins and edges on some board and chassis
parts. Contact should be made with care. Consider wearing protective gloves.
Danger of explosion if the battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the equipment manufacturer. Discard
used batteries according to manufacturer's instructions.
The system is designed to operate in a typical office environment. Choose a site
that is:
1. Clean and free of airborne particles (other than normal room dust).
2. Well ventilated and away from sources of heat including direct sunlight.
3. Away from sources of vibration or physical shock.
4. Isolated from strong electromagnetic fields produced by electrical devices.
5. In regions that are susceptible to electrical storms, we recommend you plug your
system into a surge suppresser and disconnect telecommunication lines to your
system during an electrical storm.
6. Provided with a properly grounded wall outlet.
7. Provided with sufficient space to access the power supply cords, because they
serve as the product's main power disconnect.
WARNING
Do not open the power supply. Risk of electric shock. Refer servicing of the
power supply to qualified service personnel.
(continued)
hp workstation i2000 owner's guide
23