Installation Of Upgrade Components; Verification Of The Jumper Settings; Processor Jumpers; Table 20. Processor Present (J1) - HP i2000 Owner's Manual

8.

Installation of Upgrade Components

8.1

Verification of the Jumper Settings

The following section describes the jumper settings on the boards in the i2000 system.
The Processor Present jumper (J1) on the processor board (refer to Table 20)
configures the ITP scan chain for single or dual processor mode. The jumper should be
configured to match the number of processors in the system, but is on necessary for
functional performance.
8.1.1

Processor Jumpers

Table 20. Processor Present (J1)

Single Processor Scan Chain
Present (valid)
Not Present (invalid)
Dual Processor Scan Chain
Present
Not Present
DEFAULT*
hp workstation i2000 owner's guide
1-2*
2-3
4-5
5-6*
Processor
Present (J1)
93