Pepperl+Fuchs IMUF99 B20 Series Manual page 49

Inertial Measurement Unit IMUF99*B20
Parameter Table
Index Name
0x82 Param_AF_In-
cl_x_SP1
0x83 Param_AF_In-
cl_x_SP2
0x84 Param_AF_In-
cl_x_Logic
Valid values Default value
0 ... 36000 0
0 ... 36000 0
0, 1 0
Size
[bytes] Description
2 Just use it in combination with
INX/INY/INZ inclination setting.
Don't use it with ZYZ or zy'x'' incli-
nation setting.
For inclination x-axis:
The value of this switching point
parameter determines the limit 1,
exceeding or falling below it leads to
a change in the switching status for
the application flag. The value of
Limit1 can be chosen inde-
pendently of Limit2.
2 Just use it in combination with
INX/INY/INZ inclination setting.
Don't use it with ZYZ or zy'x'' incli-
nation setting.
For inclination x-axis:
The value of this switching point
parameter determines the Limit2,
exceeding or falling below it leads to
a change in the switching status for
the application flag. The value of
Limit2 can be chosen inde-
pendently of Limit1.
1 Just use it in combination with
INX/INY/INZ inclination setting.
Don't use it with ZYZ or zy'x'' incli-
nation setting.
For inclination x-axis:
This parameter determines which
value range of the Limits should be
displayed as the "active" value
range.
• 0 = low active:
In single point mode - if the value
falls below Limit1 (independent of
sign), AF is set to "low". If Limit1 is
exceeded (independent of sign), AF
is set to "high".
In window mode - If the value is
between Limit1 and Limit2, AF is set
to "low". If the value is outside of
Limit1 and Limit2, AF is set to
"high".
• 1 = high active:
In single point mode - if the value
falls below Limit1 (independent of
sign), AF is set to "high". If Limit1 is
exceeded (independent of sign), AF
is set to "low".
In window mode - If the value is
between Limit1 and Limit2, AF is set
to "high". If the value is outside of
Limit1 and Limit2, AF is set to "low".
49