Pepperl+Fuchs IMUF99 B20 Series Manual page 50

Inertial Measurement Unit IMUF99*B20
Parameter Table
Index Name
0x85 Param_AF_In-
cl_y_Mode
0x86 Param_AF_In-
cl_y_SP1
0x87 Param_AF_In-
cl_y_SP2
50
Valid values Default value
0. 1, 2 0
0 ... 36000 0
0 ... 36000 0
Size
[bytes] Description
1 Just use it in combination with
INX/INY/INZ inclination setting.
Don't use it with ZYZ or zy'x'' incli-
nation setting.
For inclination y-axis:
0 = deactivated; The status of the
application flag is statically "inac-
tive". Set limits are ignored.
1 = single point; The status of the
application flag only switches
depending on Limit1. Limit2 is
ignored.
2 = windows; The range of values
between Limit1 and Limit2 deter-
mines the status of the application
flag. The value for Limit1 and Limit2
can be selected independently of
each other.
2 Just use it in combination with
INX/INY/INZ inclination setting.
Don't use it with ZYZ or zy'x'' incli-
nation setting.
For inclination y-axis:
The value of this switching point
parameter determines the limit 1,
exceeding or falling below it leads to
a change in the switching status for
the application flag. The value of
Limit1 can be chosen inde-
pendently of Limit2.
2 Just use it in combination with
INX/INY/INZ inclination setting.
Don't use it with ZYZ or zy'x'' incli-
nation setting.
For inclination y-axis:
The value of this switching point
parameter determines the Limit2,
exceeding or falling below it leads to
a change in the switching status for
the application flag. The value of
Limit2 can be chosen inde-
pendently of Limit1.