Model And I/O Overview; Solid-State Digital Outputs - HORNER APG XL10 PRIME OCS User Manual

8.3

Model and I/O Overview

EXL10/XL10
PRIME DC In
Models
Model 0
Model 2
12
Model 3
12
Model 4
24
Model 5 12
Model 6
12
Table 8.1 shows the different types of I/O included with the various EXL10/XL10 PRIME OCS models.
Specific specifications, jumper settings and wiring diagrams can be found on the data sheets attached at
the end of the manual. Descriptions and applications of the different type of I/O can be found below.
*up to 6mA/V In, mA/V RTD/TC, and 4mA/V Out.
8.4

Solid-State Digital Outputs

Solid-state digital outputs are generally used to activate lamps, low voltage solenoids, relays and other low
voltage and low current devices.
NOTE: The digital outputs used on the EXL10/XL10 PRIME OCS are "sourcing" outputs. This means the
output applies a positive voltage to the output pin when turned ON. When turned off, the output applies
approximately zero volts with respect to the I/O ground.
J u l y 6 , 2 0 2 2
Table 8.1 – I/O and Model Overview
DC Out Relays HS In
6 4
12 4
16 4
12 4
12 4
10 - 30VDC
LOAD
LOAD
LOAD
Figure 8.4 – Typical Output Wiring
MAN1029-10-EN_EXL10_XL10P_UM
HS Out mA/V In
4
2 2
2 2
2
2 6*
J2
0V
V+
J4
Q16
Q15
Q14
mA/V
mA/V Out
RTD/Tc
2 2
6* 4*
P a g e 78 | 195