Analog Input Configuration - HORNER APG XL10 PRIME OCS User Manual

7.7

Analog Input Configuration

The following figure illustrates the Analog Input Configuration dialog of a Model 2. To open the I/O
configuration dialogs, select Controller → Hardware Configuration → Local I/O → Config (top button)
→ Module Setup.
The Channel x drop down windows allow the user to specify the mode for each analog input to operate.
The Channel x drop down windows are enabled/disabled according to which model is being configured.
All of the models have the following modes available:
0..10V
-
0..20mA
-
4..20mA
-
On Model 5 and Model 6 I/O, other options on channels are outlined below:
Model 5
Channels 1 & 2
0..10V
0..20mA
4..20mA
100mV
PT100 DIN RTD, 1/20°C
Type J Thermocouple, 1/20°C
Type K Thermocouple, 1/20°C
Type N Thermocouple, 1/20°C
Type T Thermocouple, 1/20°C
Type E Thermocouple, 1/20°C
Type R Thermocouple, 1/20°C
Type S Thermocouple, 1/20°C
Type B Thermocouple, 1/20°C
* The Filter Constant provides filtering to all channels.
J u l y 6 , 2 0 2 2
Figure 7.9 – Analog Input Configuration Dialog
Table 7.2 – Analog In for Models 5 & 6
MAN1029-10-EN_EXL10_XL10P_UM
Model 6
Channels 1-6
0..10V
0..20mA
4..20mA
Disable
0-60mV
PT100 DIN RTD, 1/10°C
PT1000 DIN RTD, 1/10°C
Type J Thermocouple, 1/10°C
Type K Thermocouple, 1/10°C
Type N Thermocouple, 1/10°C
Type T Thermocouple, 1/10°C
Type E Thermocouple, 1/10°C
Type R Thermocouple, 1/10°C
Type S Thermocouple, 1/10°C
Type B Thermocouple, 1/10°C
P a g e 71 | 195