Terex ASV SR70 Service & Repair Manual page 86

12-27
14. Lay the angle iron across the fenders (or fuel tank
if still in place) and attach one or two tie down
straps to serve as a sling to hold the hydraulic
pumps up in position during engine removal. (fig.
12-27)
12-28
15. Disconnect the ground strap from the upper cross-
member. (fig. 12-28)
12-29
16. Attach a lifting chain or cable to the lift points on
the engine. (fig. 12-29)
12-30
17. Attach a device capable of safely lifting the engine
to the lifting chain as shown. (fig. 12-30) (see note)
12-31
Note: The rear cab window is directly over the lift point
of the engine. It is important to use an engine lifting
device that is low in profile and can reach forward
between the engine and chassis (as shown in fig. 12-
30) or the rear window could be damaged. (fig. 12-31)
12-32
18. Slide the engine rearward to clear the forward
motor mounts, then up and out between the radia-
tor supports. (fig. 12-32)
Installation
1. To install the engine, reverse the removal proce-
dure.
Note: When reinstalling the engine, lightly grease the
rubber motor mount surfaces to allow the engine to
slide onto them without snagging or disfiguring them.
Once the engine has been installed, make sure to
properly reconnect and install all items removed during
engine removal to ensure proper operation.
Prior to starting, make sure all fluids are at appropriate
levels and that they have not been contaminated with
dirt or debris during service. Change fluids or adjust
fluid levels as needed to ensure proper operation.
12-7
https://tractormanualz.com/
Rubber Track Loader
12. Engine
!WARNING!