Joystick - Terex ASV SR70 Service & Repair Manual

Rubber Track Loader
10. Lift-Arm/Drive Controls
1. Relax all hydraulic actuators to relieve pressure in
the hydraulic system prior to service.
2. Turn the ignition switch to the OFF position,
remove the key and disconnect the battery to
avoid accidental start.
3. Perform the interior side panel removal procedure
that addresses the joystick you plan to remove on
page 6-4 or 6-5 of this manual.
10-1
4. Expose and cut the zip tie securing the lower por-
tion of the boot to the joystick body, then lift it
upwards. (figure 10-1)
Magnet
10-2
Note: The float magnet is now exposed as well as the
mounting bolts securing the joystick to the bracket.
(figure 10-2)
5. Label each of the hoses during the removal
process to aid in reassembly.
Remove (optional)
10-3
6. Remove the bolts (3) securing the joystick mount-
ing bracket to the cab from the outside. (fig. 10-3)
(optional)
7. Label the hydraulic hoses to aid in reassembly
(see page 3-7 or 3-8 for routing and identification).
10-4
10-5
8. Disconnect the hydraulic hoses from the various
joystick fittings and lay them aside. (fig. 10-4,10-5)
10-6
9. Disconnect all connectors coming from the joystick
harness. (fig. 10-6)
10-2
https://tractormanualz.com/