Track Installation - Terex ASV SR70 Service & Repair Manual

Rubber Track Loader
4. Maintenance

Track Installation

1. Slide the track over the drive sprocket at the rear
of the machine. (fig. 4-23, 4-24)
2. Slide the front of the track into position for installa
tion. (fig. 4-25)
3. Lubricate the inner front wheel(s) and the inside of
the front portion of the track with a spray lubricant.
(fig. 4-26)
4. Attach a ratchet strap to the upper front portion of
the track and the other end to one of the tow
hooks on the front of the machine. (fig. 4-27)
5. Tighten the strap until the track is pulled upward
slightly and in position to slide over the inner idler
wheel(s) at the front. (fig. 4-27)
6. Pull all of the slack forward and make sure the
track drive lugs are properly meshed with the
sprocket to provide as much slack as possible for
installation.
7. If you have an assistant, have them pull the track
forward while you push inward on the track. Work
the track over the wheel(s) and into place.
8. If you do not have an assistant, push the track for
ward in inward in a quick forceful motion to slide
the track into place. The ratchet strap will help to
keep the track in place while you work it over
the idler(s). (fig. 4-28)
4-23
4-24
4-25
4-26
4-27
4-28
4-8
https://tractormanualz.com/