Machine Label And Decal Examples - Terex ASV SR70 Service & Repair Manual

Machine Label and Decal Examples

Examples of the labels and decals displayed on the
machine are shown on this page.
DANGER
Keep out from under raised lift arms!
Do not go beneath raised lift arms unless the lift arm
brace has been properly installed. See operation and
maintenance manual for installation procedure.
Failure to observe or comply with warnings may result in
serious injury or even death.
WARNING
Follow instructions closely!
Failure to install lift arm brace correctly
may result in personal injury or death.
WARNING
CAUTION
2045-466
NEVER GO BENEATH UNSECURED LIFT ARMS
1. Remove any attachment from the machine.
2. Have an assistant remove the lift arm brace from its stowed position.
3. Start the engine and carefully raise the lift arms.
4. Have the assistant install the brace around the exposed portion of the lift cylinder rod.
5. Have the assistant secure the brace to the rod with the retaining pins, then stand clear.
6. Slowly lower the lift arms until they come to rest on the brace.
7. Shut the engine off and carefully exit the machine.
8. Reverse this procedure to lower and re-secure the lift arm brace.
Keep away from tracks while machine is in motion.
Serious personal injury or even death may result.
Inspect undercarriages daily for accumulation of
debris. Build-up of debris may shorten component
life and decrease machine performance.
https://tractormanualz.com/
2-Speed
(if equipped)
To engage:
Press the button located
on the front of the right
joystick control.
To disengage:
Press the button a sec-
ond time.
WARNING
Brushcutting
Brushcutting, mowing or
operations that generate
airborne debris can
cause fires.
With the engine off
and cool:
1. Inspect the engine
compartment and any
other areas containing
hot or rotating parts
2. Thoroughly clean
these areas as often
as necessary to
avoid combustion.
Failure to do so could
result in fire that may
cause machine damage,
personal injury, or even
death.
2045-468
2045-646
2045-467
1-5
Rubber Track Loader
1. Product Safety
WARNING
Entering & Exiting
Maintain 3-point contact
with step and hand rails.
Pre-Start Checklist
1. Operator seated in
cab.
2. Seat belt fastened.
3. Lap bar pivoted down.
4. Joystick controls in
neutral position.
5. Quick attach switch in
locked position.
6. High & low flow auxil-
iary switches off.
Engine Warm-Up
Allow the engine to
warm up prior to opera-
tion.
Carrying Loads
Carry loads low. Load,
unload and turn on level
ground.
Inclines
Travel with heaviest end
of machine facing uphill.
Riders
Riders not permitted.
Work Platform
Never use a work tool as
a work platform.
Disclaimer
Failure to observe and
comply with the warn-
ings listed above may
result in machine dam-
age, personal injury, or
even death.
2045-469
DANGER
Prior to Operating
Read and fully under-
stand the operation and
maintenance manual
prior to operating this
machine.
Operating Position
Never operate the
machine with any part of
your body protruding
out of the operator
enclosure.
Failure to do so may
result in serious injury or
even death.
2045-472