Terex ASV SR70 Service & Repair Manual page 82

12-8
4. Remove the tension springs that secure the middle
pipe section to the head (upper) pipe and muffler
inlet (lower) pipe. (fig. 12-8)
12-9
5. Remove the upper and middle pipe sections from
the machine. (fig. 12-9)
12-10
6. Remove the clamps that secure the inlet and outlet
pipes to the muffler. (fig. 12-10)
Note: Thoroughly coat all clamped exhaust pipe joints
with a penetrating lubricant prior to attempting to
remove the pipe sections from the muffler. This will
make removal significantly easier.
Spring
12-3
https://tractormanualz.com/
12-11
7. Remove the inlet pipe from the muffler. It may be
necessary to use levers to force the inlet pipe sec-
tion out of the muffler. (fig. 12-11)
Note: Use caution not to damage the pipe or connec-
tion point during removal.
12-12
8. Remove the tail pipes from the muffler. If neces-
sary, tap the pipes lightly with a rubber mallot or
dead blow hammer to loosen the joints. (fig. 12-12)
Note: Use caution when striking the pipes with a mal-
lot. The pipes are easily damaged and may be disfig-
ured by the blows.
12-13
9. Remove the four bolts (and nuts) securing the muf-
fler to the chassis, then remove the muffler. (fig,
12-13).
Rubber Track Loader
12. Engine