Terex ASV SR70 Service & Repair Manual page 89

Rubber Track Loader
13. Undercarriage
3. Clean the threads on the turnbuckle thoroughly
using a stiff bristle brush.
13-2
13-3
4. Loosen the lock nut on the turnbuckle and spin it
to the end of the threaded shaft to allow clearance
when the drive table is lowered. (fig. 13-2)
5. Rotate the turnbuckle and lower the drive table as
far as it will go. (fig. 13-3)
13-4
13-5
6. Remove the bolts securing the outer wheel to
the hub. Then remove the wheel. (fig. 13-4, 13-5)
13-6
7. Remove the outer scraper plate from the suspen-
sion rail. (fig. 13-6)
13-7
13-8
8. Remove the bolts securing the inner wheel to the
hub, then remove the wheel. (fig. 13-7, 13-8)
9. Repeat this procedure as necessary to remove the
15" idler wheels throughout the undercarriage.
Note: To remove the 10" bogie wheels on the SR-80
undercarriages, refer to page 13-3 of this manual.
Installation
1. To install the 15" idler wheels, reverse the removal
procedure. Torque the wheel mounting bolts
upon installation to 90 +/- 10 Lb. Ft.
13-2
https://tractormanualz.com/